What size truck will the Versa-Gate fit? Four sizes of Versa-Gate will fit almost any size truck, from the small to the wide body Return to top of page
How do I determine which size Versa-Gate to order for my truck? Measure the height of the bed of the truck. The Versa-gate should be about 2” shorter than the bed height. Return to top of page
How much weight will the Versa-Gate hold? You should never put more weight on the tailgate than the manufacturer recommends, usually 100 lbs. Return to top of page
Do I need any tools to install the Versa-Gate? The only tool used is a small hex wrench which we provide. Return to top of page
Does the Versa-Gate install permanently on my truck? No – that is the versatility of the Versa-Gate. It can be removed and installed on another truck of the same size just by readjusting the hold-down cable. Return to top of page
If it doesn't install permanently, how do I keep it secure? Each pressure clamp has a built-in lock hasp for that purpose. Just install a small lock on the hasp for security. Return to top of page
Will the Versa-Gate work with a drop-in bed liners? Yes, the Versa-Gate will work with bed liners in place, whether they are drop-in or sprayed on. Return to top of page
Some tailgates have a small 3" cap on them. Will this matter? Yes, this matters. The Versa-Gate will not work with these caps. Return to top of page
How long does it take to install the Versa-Gate? The initial installation, which sets tension on the hold-down cable takes approximately 2 minutes. After that the Versa-Gate can be installed in about 30 seconds. Return to top of page
Once the Versa-Gate is installed, do I ever need to adjust it? Generally no – but you should occasionally check the hold-down cable tension due to road vibration. Return to top of page
When I use the Versa-Gate as a cargo divider, will it work anywhere in the bed? Yes, but it will work best between the wheel wells. You can get more tension in that location. Return to top of page
If I need to store the Versa-Gate, can I leave it in the bed of the truck? Yes, storage is easy. You can install it as a cargo divider at the front of the bed, put it behind the seats or hang it on the wall of your garage. Since it is only about 4” thick, it takes up very little space. Return to top of page
Will the Versa-Gate work with Toyota Tundra? NO, Toyota uses a different latch for the tailgate. We will create a cable hold-down latch for the Toyota in the future. Return to top of page
